ICAMS / Interdisciplinary Centre for Advanced Materials Simulation

Advanced Study Group Processing and Characterization (IEHK)

See also for this department: Members Publications

Microstructure evolution of binary and multicomponent manganese steels during selective laser melting: phase-field modeling and experimental validation

J. Kundin, A. Ramazani, U. Prahl, C. Haase.

Metallurgical and Materials Transactions A, 50, 2022-2040, (2019)

Microstructure evolution of the Fe-18.5Mn-Al-C alloy during SLM. The temperature gradient 4.6 x 10 6 K/m and the cooling rate 3 x 10 5 K/s. The concentration fields of Mn, Al, C are shown in mass fractions.

Abstract
In additive manufacturing processes, solidification velocities are extremely high in comparison to ordinary directional solidification. Therefore, the dependencies of the primary dendrite arm spacing (PDAS) on the process parameters deviate from the dependencies predicted by standard analytical methods. In this work, we investigate the microstructure evolution and element distribution in Fe-18.9Mn and Fe-18.5Mn-Al-C alloys solidified during the selective laser melting process. A quantitative multicomponent phase-field model verified by Green-function calculations (Karma, Rappel: Phys. Rev. E, 1998, 57, 4323) and the convergence analysis is used. The resulting non-standard dependencies of the PDAS on the process parameters in a wide range of solidification velocities are compared with analytical calculations. It is shown that the numerical values of the PDAS are similar to the values predicted by the Kurz–Fisher method for the low and intermediate solidification velocities and are smaller for the solidification velocities higher than 0.03 m/s. The PDAS and the Mn distribution in a Fe-18.5Mn-Al-C alloy are compared to the experimental results and a very good agreement is found.


DOI: 10.1007/s11661-019-05143-x
Download BibTEX

« back